Cleat Replacement

Step 1: Using a 4mm (Allen wrench) hex tool, remove 4 bolts per peg. Remove cleats from peg bases.
Step 2: Before installing new cleats, make sure all surfaces are clean and apply one drop of medium strength Loctite Blue #242 (or equivalent) to the threads of each of the 8 bolts.
Step 3: Install new cleats to bases using the provided bolts. Install each bolt by hand before tightening. With all bolts installed, tighten each bolt to a torque spec. of 8.3 lbs/ft (100 lbs/in.) or (11.3 N/m).

Check out the other ProTaper Installation Guide here