 |
 |
|
Waag Hummer Nerf Bars
|
|
|
WAAG Side Tubes: Just the Facts
Fast and easy installation. Most applications take 30 minutes or less.
Always bolt-on, no-drill installations that require everyday tools.
Heavy-gauge 3-inch diameter tubing and heavy duty brackets.
Brackets mount to frame only or to vehicle body pan only. WAAG side tubes NEVER mount to both frame and body pan because it is prone to creaking and will weaken over time.
Frame mounts attach to existing frame holes or clamp on to frame.
Body mounts attach to existing holes on body pan.
Black non-skid steps for sure footing.
Our five-stage powder coat finish resists chipping and fading, even after years of use.
Adjustable settings on many models.
|
|
| |
|
| |
Wheel-to-Wheel Side Tubes for Pickups
Rear step on side tube allows easy access to bed.
Frame mounted only to provide maximum strength. No body pan mounts.
Available for all full-size pickups, long beds, short beds and duallys, 2, 3, and 4 door.
One-piece construction per side. No alignment hassles as with two-piece units.
"Kick Out" tubes for duallys flare out at rear with step to follow the lines of rear fender.
Further Information:
WAAG Side Tubes are made with 3” O.D., .090 gauge round tubing. The tubes come with black non-skid steps. All WAAG products have a durable five-stage satin-black powdercoat finish, which resists chipping and fading. The Side Tube brackets are also engineered so to utilize existing factory mounting locations and avoid cutting.
Cutting and drilling, in many cases, can void a vehicle manufacturer rust warranty, which is a major concern for consumers in areas with seasonal snow fall and salted roads. From a consumer/installer standpoint, “bolt on, no cutting and drilling” offers several advantages:
First, “bolt on” is almost always an easier installation and requires no guesswork on the part of the installer.
Second, no cutting and drilling requires no special tools or modification of the vehicle.
Finally, because WAAG utilizes factory mounting locations, our Side tubes consistently mount evenly on the vehicle with little or no adjustment.
The Wheel-to-Wheel side tubes are frame mounted to ensure rigidity from front to back. By frame mounting our side tubes, we are able to offer a rear support bracket near the end of the tube that provides support when accessing the truck bed or tool box. Because the truck cab and truck bed move independently on the truck frame, a body-mounted full length side tube — if mounted to the cab and bed — would likely fail (as our competitors have found out), resulting in creaking and potentially structural breakdowns in either the body pan or the side tube brackets.
|
|
 |
|